Qlogic QLA2300 Installation Guide download pdf (Page 21)

A – Fast!UTIL Configuration Settings

FC2251101-00 D A-3

Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL

selectable boot setting. To boot from an FC hard disk attached to the QLA23xx

board, select the QLA23xx board FC hard disk on the system BIOS.

NOTE: This option applies only to hard disks; it does not apply to tape drives and

other nondisk devices.

A.2.3

Restore Default Settings

The Restore Defaults option from the Configuration Settings menu restores the

QLA23xx board default settings.

A.2.4

Raw NVRAM Data

This option displays the adapter’s NVRAM contents in hexadecimal format. This is

a QLogic troubleshooting tool; you cannot modify the data.

A.2.5

Advanced Adapter Settings

From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter

Settings. The default settings for the QLA23xx board are listed in table A-2 and

described in the following paragraphs.

Table A-2. Advanced Adapter Settings

Setting Options Default

Execution Throttle 1–256 16

Fast Command Posting Enabled, Disabled Disabled

>4GByte Addressing Enabled, Disabled Disabled

Luns per Target 0, 8, 16, 32, 64, 128, 256 8

Enable LIP Reset Yes, No No

Enable LIP Full Login Yes, No Yes

Enable Target Reset Yes, No No

Port Down Retry Count 0–255 8

Drivers Load RISC Code Enabled, Disabled Enabled

Enable Database Updates Yes, No No

Disable Database Load Yes, No No

IOCB Allocation 1–512 buffers 256 buffers

Extended Error Logging Enabled, Disabled Disabled

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

No comments

Qlogic QLA2300 Installation Guide Page 21