Qlogic SANsurfer FC HBA Manager User's Guide download pdf (Page 163)

10 – Performing Diagnostics

Viewing the Diagnostic Test Results

FS0054603-00 C 10-11

10.4.2

Read/Write Buffer Test Results

The Read/Write Buffer Test Results section provides the following information, as

shown in figure 10-4.

Figure 10-4. Diagnostic Test Results—Read/Write Buffer Test

■ Loop ID/Status

❑ The loop ID of the HBA when operating in loop mode.

❑ The status of the test—whether the test passed or failed. The possible values:

❑ Success. The test passed.

❑ Error. A data miscompare or link status firmware error occurred.

❑ Failed. A link status error, SCSI write buffer error, or SCSI read buffer error

occurred.

❑ Unknown. The target was not present.

❑ Unsupported. The device does not support this test.

■ Data Miscompare. The possible values:

❑ 0 (no data miscompares)

❑ Device not present

❑ Get link status failed

❑ Read buffer failed

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 217 218

No comments

Qlogic SANsurfer FC HBA Manager User's Guide Page 163