Qlogic QLogic Fibre Channel Switch User's Guide download pdf (Page 10)

2 – Events and Event Logging

Configuring Port Alarm Thresholds

2-4 59060-00 03

2.6

Configuring Port Alarm Thresholds

You can configure the switch to generate alarms for selected events. Configuring

an alarm involves choosing an event type, rising and falling triggers, a sample

window, and finally enabling or disabling the alarm. You can configure port alarm

thresholds for the following port events using the SANbox Manager or the

command line interface:

 CRC errors

 Decode errors

 ISL connections

 Device logins

 Device logouts

 Loss-of-signal errors

To configure port threshold alarms using SANbox Manager, open the Switch

menu in the faceplate display, and select Port Threshold Alarm Configuration.

The Port Threshold Alarm Configuration dialog shown in prompts you to enable or

disable all alarms, select an event, set triggers, set a sample window and enable

or disable an individual alarm. Refer to the Switch Management User’s Guide for

your switch for more information about port threshold alarms.

To configure port threshold alarms using the command line interface, use the Set

Config Threshold command. Refer to the Installation Guide for your switch for

more information about the command line interface and the Set Config command.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Qlogic QLogic Fibre Channel Switch User's Guide Page 10