2 – UnixWare 7 Driver Installation Installing the qlc2200 Driver
FC0153302-00 D 2-3
2.4
Installing the qlc2200 Driver
Perform the following steps to install the qlc2200 driver in a previously installed
UnixWare 7.0 or 7.1 system.
1. Make sure you have root privileges.
2. Enter the following text at the prompt to run the pkgadd program:
pkgadd -d diskette1
3. The following prompt appears:
Insert diskette into Floppy Drive 1.
Type [go] when ready,
or [q] to quit: (default: go)
4. Insert the diskette that contains the QLogic driver into drive 1 and press
<ENTER> to select [go].
5. You are prompted to select a driver package. For example:
Installation in progress. Do not remove the
diskette.
The following packages are available:
1 qlc2200 QLogic QLA22XX Series
IHV HBA (i386) 3.01
Select packages(s) you wish to process (or ’all’
to process all packages). (default: all)
[?,??,quit]:
6. Type 1 and press <ENTER> to install the qlc2200 driver.
7. When the driver is installed, the following prompt appears:
Installation of QLogic QLA22XX Series
IHV HBA (qlc2200) was successful.
Insert diskette into Floppy Drive 1.
Type [go] when ready,
or [q] to quit: (default: go)
8. Type q and press <ENTER> to exit the installation program.
9. Remove the diskette that contains the QLogic driver.
10. Reboot the system to load the driver.
Comments to this Manuals