Qlogic QLA22xx board Installation Guide download pdf (Page 16)

Windows NT Installation 4 – Windows NT Driver Installation

4-2 FC0153302-00 D

4.3.1

Initial Installation of Windows NT and the Windows NT Driver

Perform the following steps to install Windows NT 4.0 on the Fibre Channel drive

attached to the QLA22xx board.

1. Insert the Windows NT setup diskette or CD (if booting from a bootable

CD-ROM drive) in an appropriate drive.

2. Reboot your system.

3. Press <F6> to Install Additional Devices.

4. Press s to specify an additional device.

5. Select Other, then press <ENTER>.

6. Insert the diskette that contains the QLogic driver into an appropriate disk

drive, then press <ENTER>.

7. Select QLogic QLA2200 PCI Fibre Channel Adapter, then press

<ENTER>.

8. Follow the standard Windows NT installation instructions to complete the

Windows NT setup.

4.3.2

Installing or Updating the Windows NT Driver

Perform the following steps to add the Windows NT driver to a previously installed

Windows NT 4.0 system.

NOTE: This procedure restores the default Registry parameters for the QLA22xx

Windows NT driver.

1. Select My Computer from the desktop.

2. Select Control Panel.

3. Select SCSI Adapters.

4. Select the Drivers tab and click Add.

5. Insert the diskette that contains the QLogic driver into an appropriate drive

and click Have Disk.

6. Type the path to the NT driver. For example:

A:\NT

7. Click OK.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

No comments

Qlogic QLA22xx board Installation Guide Page 16