Qlogic QLA22xx board Installation Guide download pdf (Page 31)

FC0153302-00 D 6-1

Section 6

Solaris SPARC Driver Installation

(QLA2200)

6.1

Introduction

This section provides instructions for installing the Solaris SPARC driver in an

already installed Solaris SPARC operating system.

The latest version of the Solaris SPARC driver package is available on the QLogic

web site. The files in the driver package cannot be read nor installed from a DOS

environment. Be sure to review the README.TXT for both new and changed

information.

6.2

Installing the Solaris SPARC Driver

Perform the following steps to install the QLA2200 driver in a previously installed

Solaris SPARC system.

NOTE: To install the QLA2200 driver, you must have super-user privileges.

1. Logon to the system as a superuser.

2. Insert the diskette that contains the QLogic driver in the first floppy drive.

3. Enter the following text to stop the Volume Manager:

/etc/init.d/volmgt stop

4. Enter the following text to run the package add (pkgadd) program:

pkgadd -d /dev/rdiskette0

NOTE: If you downloaded the driver package from the QLogic web site,

you must first uncompress the file before running the pkgadd

program.

5. You are prompted to insert a diskette. For example:

Insert diskette into Floppy Drive.

Type [go] when ready,

or [e] to eject the diskette,

or [q] to quit:

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

No comments

Qlogic QLA22xx board Installation Guide Page 31