Qlogic QLA22xx board Installation Guide download pdf (Page 14)

Installing the NetWare Driver 3 – NetWare Driver Installation

3-2 FC0153302-00 D

Perform the following steps to install the NetWare driver in a previously installed

NetWare 4.X or 5.X system.

NOTE: The following procedure modifies your NetWare STARTUP.NCF file to

load the driver automatically when your system boots.

1. Start NetWare and load the NetWare Install program from the NetWare

server prompt (SERVERNAME:).

Type the following command if you are using NetWare 4.X:

LOAD INSTALL

Type the following command if you are using NetWare 5.X:

LOAD NWCONFIG

2. Select Driver options from the main menu.

3. Select Configure disk and storage device drivers.

4. Select Select an additional driver.

5. Press <INSERT> to install an unlisted driver.

6. Insert the diskette that contains the QLogic driver in an appropriate drive.

7. Press <ENTER> to scan the diskette for the QLogic driver.

8. Press <ENTER> to select the QL2200.HAM driver.

9. If prompted, select Yes to copy the driver.

10. You are prompted for the server directory. Type the path of the server

directory, or press <ENTER> to accept the default.

11. If necessary, select Select/Modify Driver Parameters to modify the default

settings.

12. Press <F10> to save the parameter settings.

13. Select Save parameters and load driver to complete the NetWare set up.

NOTE: If ASPI support is required for the SCSI devices, you must load the

NWASPI.CDM module, which is provided by Novell. For example:

LOAD QL2200.HAM

LOAD NWASPI.CDM

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

No comments

Qlogic QLA22xx board Installation Guide Page 14